# -*- text -*-
#
# Copyright (c) 2004-2005 The Trustees of Indiana University and Indiana
#                         University Research and Technology
#                         Corporation.  All rights reserved.
# Copyright (c) 2004-2005 The University of Tennessee and The University
#                         of Tennessee Research Foundation.  All rights
#                         reserved.
# Copyright (c) 2004-2005 High Performance Computing Center Stuttgart,
#                         University of Stuttgart.  All rights reserved.
# Copyright (c) 2004-2005 The Regents of the University of California.
#                         All rights reserved.
# Copyright (c) 2008-2019 Cisco Systems, Inc.  All rights reserved
# Copyright (c) 2018      Intel, Inc. All rights reserved.
# $COPYRIGHT$
#
# Additional copyrights may follow
#
# $HEADER$
#
# This is the US/English help file for PMIX MCA error messages.
#
[find-available:not-valid]
A requested component was not found, or was unable to be opened.  This
means that this component is either not installed or is unable to be
used on your system (e.g., sometimes this means that shared libraries
that the component requires are unable to be found/loaded).  Note that
PMIX stopped checking at the first component that it did not find.

Host:      %s
Framework: %s
Component: %s
#
[find-available:none found]
No components were able to be opened in the %s framework.

This typically means that either no components of this type were
installed, or none of the installed componnets can be loaded.
Sometimes this means that shared libraries required by these
components are unable to be found/loaded.

  Host:      %s
  Framework: %s
#
[framework-param:too-many-negates]
MCA framework parameters can only take a single negation operator
("^"), and it must be at the beginning of the value.  The following
value violates this rule:

    %s

When used, the negation operator sets the "exclusive" behavior mode,
meaning that it will exclude all specified components (and implicitly
include all others).  If the negation operator is not specified, the
"inclusive" mode is assumed, meaning that all specified components
will be included (and implicitly exclude all others).

For example, "^a,b" specifies the exclusive behavior and means "use
all components *except* a and b", while "c,d" specifies the inclusive
behavior and means "use *only* components c and d."

You cannot mix inclusive and exclusive behavior.
#
[failed to add component dir]
The pmix_mca_base_component_path MCA variable was used to add paths to
search for PMIX components.  At least one directory failed to add
properly:

    %s

Check to make sure that this directory exists, is readable, etc.